Our laminate countertop BEVEL edge is a traditional beveled edge. Although beveled edges for laminate countertops have been around for decades, we make ours different. Instead of applying separate pieces of laminate to the faces, we use a single piece of laminate and a very precise miter fold to allow the laminate pattern to flow from one face to the other leaving one less seam.
Laminate Countertop BEVEL Edge Components
The substrate (backside or base) we use to manufacture our laminate countertop BEVEL edge is MR-50 rated moisture resistant medium density fiberboard (MDF). For our beveled edges and beveled backsplashes, HPL (High-Pressure Laminate a.k.a. the laminate) is glued and pressed to the substrate using high strength glue. Both ends of every piece are finished with a 90-degree cut.
All materials used in manufacturing Loti Corp edges are either no or low VOC and all of the surface and seam materials are considered waterproof.
Sizing and Profiles
Our laminate countertop BEVEL edge is manufactured at 94 3/4″ long by 1/4″ thick by 1-9/16″ high. They have a 45-degree beveled face and come with a flat back (FB) mounting surface style.
BEVEL Edge Installation
Our laminate countertop BEVEL edge can be installed by anyone with decent carpentry skills and tools. The tools and skills needed to install our beveled laminate countertop edges and beveled backsplashes are common for carpenters and countertop fabricators.
A miter saw and optionally a disk sander are needed to cut to length and miter the corners. Our BEVEL edges are composed of MDF and laminate, so no special blades are needed for cutting.
Masking tape and good waterproof wood glue, such as Titebond® III, are all that is needed for attaching our BEVEL edges to the countertop’s substrate. A damp rag is recommended for cleaning up squeeze out glue.
Finally, a good wax surface treatment is recommended if you wish to really make it shine. We recommend PROTECTALL™ Shine Plus. It’s great for the laminate countertop as well.
Warranty
Loti Corp warrants to the original owner of our BEVEL edges and BEVEL backsplashes, installed by a professional and in a professional manner, that at its option will replace this product if it fails due to any manufacturing defect during the first 10 years after initial installation, except for damage caused by excessive heat, physical or chemical abuse, or acts of nature.
The warranty is non-transferable and applies only to our laminate countertop BEVEL edges (1) installed by a professional, (2) purchased for use in the United States and its territories, Canada or Mexico, (3) which has not been moved from its original place of installation, (4) which fails solely due to manufacturing defect.
Loti Corp can not be held liable for the failure of any glue lines not produced at the time of manufacture. Warranty extends only to replacement of our BEVEL edges and does not extend to any labor and/or materials necessary for re-installation of the product. Furthermore, Loti Corp shall not be held liable for any loss, direct, consequential, or incidental damages arising out of the use of our Bevel edges and backsplashes or any other products manufactured, distributed, or recommended by Loti Corp.
8498 SW Warm Springs St.
Tualatin OR 97062
p 877.436.3343
F 503.678.2085
info@loticorp.com